Below is a selection of the more commonly used profiles and sections the use of which spans the breadth of the fabrication industry whether land or marine based.  The dimension ratios of these profiles are for the customer to determine and our in house Powder Coating plant offers a wide range of colours and finishes.

Based on the PC-G this channel is available in an almost infinite variety of height to width combinations and can be produced with an inside dimension as small as 12mm with wall height of 60mm on materials up to 3mm in thickness.
	Obtuse angles of any size and any degree of bend are covered by the base part number PA-D  and can be produced in thickness up to 3mm.
This is one of the many more complex shapes that are often required. This style will often be used as a hanging ceiling support where the vertical support is a wall board.
	The humble 90 degree angle is probably the most widely deployed profile in the fabrication of structures today. We can accurately  produce any combination of leg length and thickness in standard sheet gauges up to 3mm.
A more unusual profile formed with all internal bends often used for capping or framing.
	Top hats sections, again a very widely used profile, can be produced in many size ratio combinations and from most sheet metal.
This profile often used in framing applications.